Error Messages; Reports; Error Messages Reports - Panasonic KX-FPC141 Operating Instructions Manual

Error Messages

Reports

If your unit cannot send a fax, check the following.
– The number you dialed is correct.
– The other party's machine is a facsimile.
If the problem remains, correct it by following the communication message printed on the sending and journal
reports (p. 67, 68).
Communication message
COMMUNICATION ERROR
DOCUMENT JAMMED
ERROR-NOT YOUR UNIT
MEMORY FULL
NO DOCUMENT
OTHER FAX NOT RESPOND
PRESSED THE STOP KEY
THE COVER WAS OPENED
OK
118
For Fax advantage assistance, call 1-800-435-7329.
Error code
41–72 A transmission or reception error occurred. Try again or check
FF with the other party.
— The document is jammed. Remove the jammed document (p. 128).
54, 59 A transmission or reception error occurred because of a problem
70 with the other party's fax machine. Check with the other party.
— The document was not received due to memory being full.
— The document was not fed into the unit properly. Reinsert the
document and try again.
— The other party's fax machine was busy or ran out of recording
paper. Try again.
The document was not fed properly. Reinsert the document and
try again.
The other party's fax machine rings too many times. To send a
fax manually, dial the number, confirm the fax tone, and press
START/SET/COPY
The other party's machine is not a facsimile. Check with the
other party.
The number you dialed is not in service.
— STOP was pressed and fax communication was canceled.
— The cover was opened. Close it and try again.
— Fax communication was successful.
Cause & Remedy
.