Connections
Connect the handset cord.
Connect the telephone line cord.
Connect the power cord.
• When the power is turned on for
the first time, the unit will print
some basic information.
120 V, 60 Hz
RJ11C
Power cord
Power surge
protector
)
(Uoesu e)
protector
Telephone
line cord
-Handset cord
Connect to "LINE".
Note:
• The warranty does not cover damage due to power line surges or lightning.
For additional equipment protection, we recommend the use of a surge protector. The following types are
available; TELESPIKE BLOK MODELTSB
(TRIPPE MFG. CO.), SPIKE BLOK MODEL SK6-0 (TRIPPE
MFG. CO.), SUPER MAX (PANAMA)() or MP1 (ITW LINX).
• When you operate this product, the power outlet should be near the product and easily accessible.
• If the following message is displayed when the unit is plugged in, the recording paper set lever is released.
Display: [
CHECK LEVER
]
Move the lever back (see step 3 on page 23).
Automatic dialing mode setting
• When the telephone line cord and the power cord are connected, the unit will automatically start to detect the
dialing mode.
Display: [
CHECKING
LINE
]
Wait until one of the following messages is displayed.
If your line has touch tone service:
I LINE IS TONE
I
-- If your line has rotary pulse dial service:
I LINE IS PULSE
I
• If the power cord is disconnected or a power failure occurs, the unit will detect the dialing mode again when
power is restored.
• You can change the dialing mode setting manually. See page 33.
• If you connect the power cord before connecting the telephone line cord, the following messages will be
shown alternately.
Connect the telephone line cord.
24