Error Messages-Report - Panasonic KX-FLC418RU Service Manual

12.2. Error Messages-Report

12.2.1. Journal Report
1. Press the MENU button.
2. Press "#", then "8" and "3".
3. Press the SET button.
4. The report prints out.
CROSS REFERENCE:
Features(P.14)
Error code table:
(1) CODE (2) RESULT
PRESSED THE STOP KEY
DOCUMENT JAMMED
NO DOCUMENT
THE COVER WAS OPENED SND
28 COMMUNICATION ERROR
40 COMMUNICATION ERROR
41 COMMUNICATION ERROR
42 COMMUNICATION ERROR
43 COMMUNICATION ERROR
44 COMMUNICATION ERROR
46 COMMUNICATION ERROR
48 COMMUNICATION ERROR
49 COMMUNICATION ERROR
50 COMMUNICATION ERROR
51 COMMUNICATION ERROR
52 COMMUNICATION ERROR
54 ERROR-NOT YOUR UNIT
58 COMMUNICATION ERROR
59 ERROR-NOT YOUR UNIT
65 COMMUNICATION ERROR
65 COMMUNICATION ERROR
68 COMMUNICATION ERROR
70 ERROR-NOT YOUR UNIT
72 COMMUNICATION ERROR
75 MEMORY FULL
79 CANCELED
FF COMMUNICATION ERROR
SND=TRANSMISSION / RCV=RECEPTION
Most fax communication problems can be resolved by the following steps.
1. Change the transmit level. (Service code: 596, refer to Service Function Table (P.94).)
1. Change the TX speed/RX speed. (Service code: 717/718, refer to Service Function Table (P.94).)
Note*:
If the problem remains, see the following "Countermeasure" flow chart.
(3) MODE
SND & RCV Communication was interrupted by the STOP button.
SND The document paper is jammed.
SND No document paper.
The cover is open.
SND & RCV ---------
SND Transmission is finished when the T1 TIMER expires.
SND DCN is received after DCS transmission.
SND FTT is received after transmission of a 2400BSP training signal.
SND No response after post message is transmitted three times.
SND RTN and PIN are received.
RCV No response after FTT is transmitted.
RCV No post message.
RCV RTN is transmitted.
RCV PIN is transmitted (to PRI-Q).
RCV PIN is transmitted.
RCV Reception is finished when the T1 TIMER expires.
RCV DCN is received after DIS transmission.
RCV DCN is received after FTT transmission.
SND DCN responds to the post message.
SND DCN is received before DIS reception.
RCV Reception is not EOP, EOM PIP, PIN, RTP or RTN.
RCV No response at the other party after MCF or CFR is transmitted.
RCV DCN is received after CFR transmission.
RCV Carrier is cut when the image signal is received.
RCV The document was not received due to memory full.
SND The multi-station transmission was rejected by the user.
SND & RCV Modem error. For the DCN, DCN, etc. abbreviations, refer to Modem
Section (P.25).
105
SYMPTOM
KX-FLC418RU
Counter-
measure*
1
2
3
4
5
6
7
8
8
8
9
11
13
14
2
2
13
13
16
12