Receiving A Fax Manually - Panasonic KX-FP151E Operating Instructions Manual

Compact plain paper fax with telephone answering system
Table of Contents

Advertisement

KX-FP151/155(E)(036-039) 01.12.19 10:09 AM Page 38
Receiving Faxes
TEL
mode!
(answering all calls manually)
Activating TEL mode
If the arrow ( ) is shown on the right of the
display, turn it off by pressing PQ.
Display:

Receiving a fax manually

When the unit rings, lift the handset.
1
You can press q (KX-FP151) /
NO (KX-FP155).
When:
2
— document reception is required,
— a fax calling tone (slow beep) is heard, or
— no sound is heard,
press j.
Display:
3
Replace the handset if you are using it.
The unit will start fax reception.
Note:
Up to 30 sheets of printed paper can be held. Remove
the printed paper before it exceeds 30 sheets.
To stop receiving
Press {.
Friendly reception feature
When you answer a call and hear a fax calling tone
(slow beep), the unit will automatically start fax
reception.
If this feature is not required, set feature #46 to off
(p. 66).
Fax reception in memory
When a printing problem is detected, the unit will
temporarily store the received document into memory.
While the document is in memory:
— the display will show an error message and the
following alternately,
— slow beeps will sound if feature #44 is set to on (p. 66).
Follow the instructions on pages 71–73 to solve the
problem.
For memory capacity, see page 81.
38
TEL MODE
CONNECTING.....
FAX IN MEMORY
Display:
Turning the AUTO ANSWER mode on
ON
remotely
When you are not in, and the AUTO
ANSWER mode of your unit is set to off (TEL
mode), you can turn the AUTO ANSWER
mode on from a remote location using a
touch tone telephone.
AUTO ANSWER mode:
— FAX only mode
— TEL/FAX mode
— TAD/FAX mode (KX-FP155 only)
For KX-FP151
1. Call your unit and wait for 10 rings.
You will hear a beep signal.
2. — To switch to FAX ONLY mode:
Press * within 8 seconds.
— To switch to TEL/FAX mode:
Press # within 8 seconds.
3. Hang up the handset.
Note:
Press * or # within 8 seconds after
hearing the beep, otherwise the call will be
interrupted and the unit will remain in the
TEL mode.
For KX-FP155
1. Call your unit and wait for 10 rings.
You will hear a beep signal.
2. Enter the remote operation ID (feature #11
on page 63) within 8 seconds.
You will hear a beep signal.
3. — To switch to FAX ONLY mode:
Press * within 3 seconds.
— To switch to TEL/FAX mode:
Press # within 3 seconds.
— To switch to TAD/FAX mode:
Wait for 3 seconds, then the greeting
message will be played.
4. Hang up the handset.
Note:
Enter the remote operation ID within 8
seconds after hearing the beep, otherwise
the call will be interrupted and the unit will
remain in TEL mode.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Kx-fp155e

Table of Contents