Configuration Information - HP D6000 Quickspecs

QuickSpecs

Configuration Information

Step 2b - SAS Cable
Model Description
mini-SAS 4x 1M Cable All
mini-SAS 4x 2M Cable All
Step 3 - D6000 Drive Options
3.5" SAS Midline (MDL) Drives
HP 3TB 6G SAS 7.2K rpm LFF (3.5-inch) Midline 1yr Warranty Hard Drive
HP 1TB 6G SAS 7.2K rpm LFF (3.5-inch) Dual Port Midline 1yr Warranty Hard Drive
HP 2TB 6G SAS 7.2K rpm LFF (3.5-inch) Dual Port Midline 1yr Warranty Hard Drive
3.5" SAS Drives
HP 300GB 6G SAS 15K rpm LFF (3.5-inch) Dual Port Enterprise 3yr Warranty Hard Drive
HP 450GB 6G SAS 15K rpm LFF (3.5-inch) Dual Port Enterprise 3yr Warranty Hard Drive
HP 600GB 6G SAS 15K rpm LFF (3.5-inch) Dual Port Enterprise 3yr Warranty Hard Drive
Step 4: Choose Rack Options
Choose HP Rack 10000 series Cabinets for the D6000
The increasing power of new high-performance processor technology requires increased cooling efficiency for rack-mounted servers.
The 10000 Series Racks provide enhanced airflow for maximum cooling, allowing these racks to be fully loaded with servers using the
latest processors.
http://h18004.www1.hp.com/products/servers/proliantstorage/racks/10000series/index.html
NOTE: An D6000 fully loaded with drives weighs 320lbs.
NOTE: HP has not tested or validated the D6000 with any third-party racks. Before installing the D6000 in a third-party rack, be sure to
properly scope the limitations of the rack. Before proceeding with the installation, consider the following:
You must fully understand the static and dynamic load carrying capacity of the rack and be sure that it can accommodate the
weight of the D6000 .
If the D6000 is not sitting atop a Blade c-Class enclosure or another D6000 or MDS600, then install a 1U tray beneath the D6000
to ensure proper support
Be sure sufficient clearance exists for cabling, installation and removal of the enclosure, actuation of the rack doors, and full
articulation of the drive drawers
NOTE: Please note that while configured as CTO, a maximum of four D6000 is supported in a 42u standard rack (AF002A) and five in a
42u deep rack(AF092A). The 47U deep rack ( AF094A) will also be limited to a maximum of five D6000 for CTO config. But additional
D6000 can still be ordered as BTOs. Customers can then install them into racks at the customer site for a maximum of six D6000 per
rack. The quantity of D6000 units supported in a rack is dependent upon the other components configured in the rack relative to the
rack weight limit.
DA - 14419 Worldwide — Version 3 — February 15, 2013
HP D6000 Disk Enclosure
407337-B21
407339-B21
625031-B21
507614-B21
507616-B21
516814-B21
516816-B21
516828-B21
Page 11