Control Of The Tv - Sharp LE650U Operation Manual

Using a PC

Control of the TV

The TV can be controlled from a PC, control panels and other devices using the RS-232C or IP.
Use a cross-type RS-232C cable, ETHERNET cable (commercially available) or wireless LAN for
the connections.
NOTE
This operation system should be used by a person who is accustomed to using computers.
AQUOS Remote Control
Set this function when operating the TV from equipment connected by LAN or wireless LAN. To
perform the operation, refer to "Smart TV".
Remote Control App
When "Remote Control App" is selected, "Change" will be highlighted. Press ENTER.
Detailed Settings
Make the detailed settings (Login ID, password, etc.).
Follow the on-screen instructions to configure the settings.
NOTE
On the UD1U model, you cannot operate the "AQUOS Remote Control" function during 4K60P
signal input. Operate this function during the input of other types of signals (such as Full HD).
TV Name Setting
Set the name of the TV displayed on other network devices.
Use the software keyboard to set the name.
See page 9-5 for details on the software keyboard.
NOTE
On the UD1U model, you cannot operate the "TV Name Setting" function during 4K60P signal
input. Operate this function during the input of other types of signals (such as Full HD).
Communication Conditions for IP
Connect to the TV with the following settings made for IP on the PC.
IP protocol:
Host IP address:
Service:
TCP port#:
When you set your ID and password on the TV menu, you need to enter them as soon as you
connect to the TV.
NOTE
When you use this function, make settings for "AQUOS Remote Control".
The connection will be cut off when there has been no communication for 3 minutes.
Communication Conditions for RS-232C
Set the RS-232C communication settings on the PC to match the TV's communication conditions.
The TV's communication settings are as follows:
Baud rate:
Data length:
Parity bit:
Stop bit:
Flow control:
Communication procedure
Send the control commands from the PC via the RS-232C or IP.
The TV operates according to the received command and sends a response message to the PC.
Do not send multiple commands at the same time.
Wait until the PC receives the OK response before sending the next command.
ENG 8-3
TCP/IP
Set the IP address on the TV menu
None (Do not select Telnet or SSH)
Set a port number on the TV menu (Control port)
9,600 bps
8 bits
None
1 bit
None