Using A Pc; Control Of The Tv - Sharp AQUOS 4T-C50AH1X Operation Manual

<<

Using a PC

Control of the TV

The TV can be controlled from a PC, control panels and other devices
using the RS-232C. (at 'SERVICE ONLY' terminal)
Use a cross-type RS-232C cable (commercially available) for the
connections and conversion cable to minijack. (can purchase from service
center)
NOTE
This operation system should be used by a person who is accustomed to
using computers.
AQUOS Remote Control
Set this function when operating the TV from equipment connected by LAN or
wireless LAN. To perform the operation, refer to "Smart TV" > "AQUOS
Remote Control".
AQUOS Remote Control
When "AQUOS Remote Control" is selected, "Change" will be highlighted.
Press ENTER.
Detailed Settings
Make the detailed settings (Login ID, password).
Follow the on-screen instructions to configure the settings.
Device Name
Set the name of the TV displayed on other network devices.
Configure the settings from "
TV" > "Advanced" > "TV name setting".
ENGLISH | FRANÇAIS | PORTUGUÊS | РУССКИЙ | 中文 | INDONESIA | ภาษาไทย | TIẾNG VIỆT | ‫ | ﻋرﺑﻲ‬АҒЫЛШЫН | O'ZBEK TILIDA
(HOME)" > "Settings" > "Menu" > "Smart
Communication Conditions for RS-232C
Set the RS-232C communication settings on the PC to match the TV's
communication conditions.
The TV's communication settings are as follows:
Baud rate: 115,200 bps
Data length: 8 bits
Parity bit: None
Stop bit: 1 bit
Flow control: None
Communication procedure
Send the control commands from the PC via the RS-232C.
The TV operates according to the received command and sends a response
message to the PC.
Do not send multiple commands at the same time.
Wait until the PC receives the OK response before sending the next
command.
EN 7-1
>>