D-Link dcs-910 User Manual page 53

Section 4 - Security
Repeat the above steps adding the port 80 to both the Public and Private Port sections. A check mark appearing before the entry
name will indicate that the ports are enabled.
Important: Some ISPs block access to port 80 and other commonly used Internet ports to conserve bandwidth. Check
with your ISP so that you can open the appropriate ports accordingly. If your ISP does not pass traffic on port 80, you
will need to change the port the camera uses from 80 to something else, such as 800. Not all routers are the same, so
refer to your user manual for specific instructions on how to open ports.
Enter valid ports in the Virtual Server section of your router. Please make sure to check the box next to the camera name on the Virtual
Server List to enable your settings.
D-Link DCS-910 User Manual 53