IHP BLKBP-MPDP35 Installation Instructions

INSTALLATION INSTRUCTIONS FOR PANEL KITS
FOR USE WITH MPD PRO DIRECT-VENT GAS FIREPLACES
HOT GLASS WILL CAUSE BURNS.
DO NOT TOUCH GLASS UNTIL COOLED.
NEVER ALLOW CHILDREN TO TOUCH GLASS.
• Install only when fireplace is OFF and COLD.
• Fireplace surfaces get EXTREMELY HOT!
• The glass on the front of the fireplace reaches EXTREMELY HIGH
TEMPERATURES and can cause severe burns if touched. Even after
the gas is turned off, fireplace surfaces remain extremely HOT.
• Keep children away from an operating fireplace. Closely supervise
children in any room where a fireplace is operating to prevent
contact with glass.
• Logs get very HOT and will remain HOT up to one hour after
gas supply is turned off. Handle logs only when cool. Turn OFF
all electricity to the appliance before installing grate, volcanic
stone, embers, and logs.
CAUTION
RISK OF PERSONAL INJURY OR PROPERTY DAMAGE.
• Never operate fireplace without liner panels installed.
These appliances are NOT approved for operation without liner panels.
• Do NOT abuse glass doors by striking or slamming shut
• Never operate fireplace with glass door assemby removed.
• Handle glass door assembly with extreme care. Replace damaged
glass door assembly with approved replacement assembly only.
• Use only media approved for use with these fireplaces (as appli-
cable). Failure to use approved media may result in sooting,
delayed ignition, or other improper fireplace operation, and may
void the warranty.
NOTICE
• READ ALL STEPS BEFORE STARTING INSTALLATION.
• LEAVE THESE INSTRUCTIONS WITH THE APPLIANCE.
• All warnings, precautions, and instructions in the Installation
Instructions and Care and Operation Instructions provided with the
appliance also apply to these instructions.
• If you encounter any problems, need clarification of these
instructions, or are not qualified to properly install this kit, contact
your local distributor or dealer.
P506019-95
P/N 506019-95 Rev. A 04/2015
WARNING
NOTE: DIAGRAMS AND ILLUSTRATIONS ARE REPRESENTATIVE AND ARE NOT DRAWN TO SCALE.
GENERAL INFORMATION
This document contains installation instructions for the following Panel
Kits for use with the MPD Pro direct-vent gas fireplaces manufactured
by INNOVATIVE HEARTH PRODUCTS.
Description
35" Panel Kit - Black Porcelain
35" Panel Kit - Ceramic Brick, Traditional
40" Panel Kit - Black Porcelain
40" Panel Kit - Ceramic Brick, Traditional
KIT CONTENTS
• Right Side Panel
• Left Side Panel
• Back Panel
• Rear Panel
• (4) Screws, #10x1/2 (provided with porcelain panel kits only)
REQUIRED TOOLS
NOTE: Power tools are NOT recommended when installing
porcelain-coated panels.
• 1/4" Hex Head Nut Driver
• Safety Glasses
• Protective Work Gloves
OPTIONAL TOOLS
• Non-ammoniated Glass Cleaner (for porcelain-coated panels only)
• Non-abrasive rag (for porcelain-coated panels only)
Figure 1
IHP.us.com
HEARTH PRODUCTS
KITS AND ACCESSORIES
MPD PRO PANEL KIT
MPD Pro Panel Kits
Cat. No.
H8572 BLKBP-MPDP35
H8595 BLKC-MP35
H8573 BLKBP-MPDP40
H8596 BLKC-MP40
Ceramic Brick Panels
Porcelain Panels
Model No.
1