Yamaha WR250F 2008 Owner's And Service Manual page 157

CHECKING THE OIL STRAINER
1. Inspect:
• Oil strainer
Damage → Replace.
CHECKING THE OIL DELIVERY
PIPE 2
1. Inspect:
• Oil delivery pipe 2 "1"
• O-ring "2"
Damage → Replace.
• Oil orifice "a"
Clogged → Blow.
INSTALLING THE CRANKCASE
BEARING
1. Install:
• Bearing
• Bearing stopper
• Bolt (bearing stopper)
Bolt (bearing stopper):
10 Nm (1.0 m•kg, 7.2
ft•lb)
• Screw (bearing stopper)
Screw (bearing stopper):
10 Nm (1.0 m•kg, 7.2
ft•lb)
CRANKCASE AND CRANKSHAFT
• Screw [bearing stopper (crank-
shaft)] "1"
Screw [bearing stopper
(crankshaft)]:
14 Nm (1.4 m•kg, 10
ft•lb)
To left and right crankcase.
• Install the bearing by pressing its
outer race parallel.
• To prevent the screw [bearing stop-
per (crankshaft)] from becoming
loose, crush the screw head periph-
ery "a" into the concave "b" using a
punch etc. In so doing, take care
not to damage the screwdriver re-
ceiving hole in the screw head.
INSTALLING THE CRANKSHAFT
1. Install:
• Crankshaft "1"
Use the crankshaft installing tool
"2", "3", "4" and "5".
Crankshaft installing pot
"2":
YU-90050/90890-01274
Crankshaft installing bolt
"3":
YU-90050/90890-01275
Adapter (M12) "4":
YU-90063/90890-01278
Spacer (crankshaft in-
staller) "5":
YU-91044/90890-04081
• Hold the connecting rod at top dead
center with one hand while turning
the nut of the installing tool with the
other. Operate the installing tool un-
til the crankshaft bottoms against
the bearing.
• Before installing the crankshaft,
clean the contacting surface of
crankcase.
Do not use a hammer to drive in
the crankshaft.
5-61
A. For USA and CDN
B. Except for USA and CDN
2. Check:
• Shifter operation
• Transmission operation
Unsmooth operation → Repair.
3. Install:
• Oil strainer "1"
• Bolt (oil strainer) "2"
Bolt (oil strainer):
10 Nm (1.0 m•kg, 7.2
ft•lb)
4. Apply:
• Sealant
On the right crankcase "1".
YAMAHA Bond No. 1215
®
(ThreeBond No.1215):
90890-85505
Clean the contacting surface of left
and right crankcase before applying
the sealant.