CONTROLS & FEATURES
TOUCH CONTROLS & FEATURES
1
Blower On/Off
1
Blower On/Off
By pressing
, the blower is switched On and Off. When switched on, the blower starts up on speed level 3.
2
Speed Selection
The 6 speed levels are selected by pressing
indicates level selected.
3
Delay Off
This is used for programmed shut down of blower and lights 15 minutes after the function is activated.
Press
once, a dot flashes in the lower right hand side of display
The hood will completely shut down in 15 minutes.
4
Lights On/Off/ Dim
Switch lights On and Off by pressing key
Advance Display Functions
5
Filters Clean Reminder (Metal):
After every 30 hours of use, the display will start flashing an
from residue and possible clogs.
The standard Metal Filters are required to be cleaned frequently and as recommended in order
to maintain blower efficiency. If improperly maintained, residue from cooking will sift though
filters and cause damage to hood blowers and other sensitive components; and possibly clog
duct work and creates fire hazard.
Filters Change Reminder (Carbon, if fitted):
When your hood is installed as a 'Purifying' (Ductless Recirculating) unit, it is fitted with a set of
Carbon Filters to purify exhaust and fumes from cooking, and re-circulates the air within the home.
These Carbon Filters are required to be replaced after every 120 hours of use. The Filter Change
Reminder function in the microprocessor needs to be switched on. The microprocessor in the
controls when set, will elapsed and count usage time and indicate when carbon filter replacement is
needed every 120 hrs.
5
Display
(Speed level, Delay Off Indicator, Filter Clean/ Change)
2
Adjust 6 Speed Levels
3
to decrease and
once. To dim lights, press and hold-
4
Lights On/Off/ Hold to Dim
15 Min Delay Off
to increase speed level. The display
indicating the function is on.
for 2 seconds.
reminding you to clean the metal filters
7
Need help?
Do you have a question about the ZML-M90S/G and is the answer not in the manual?
Questions and answers