Panasonic CQ-DX200W Operating Instructions Manual page 58

Bluetooth (continued)
Notes:
¡ This setting is feasible only in the Bluetooth mode.
¡ Each item can be set in the BT HF mode and BT
AUDIO mode independently.
1
Hold down [VOL-
UME] (PUSH SEL:
SELECT) for 2
sec.or more.
2
Press [PUSH SEL:
SELECT] to select a
mode to be adjusted.
For using the remote
control, use [SEL].
3
Perform each set-
ting.
PAIRING
Establishment of pairing with the devices to be connected
Note: This is displayed only when no information about
the connected devices last time exists.
Press [BAND].
Notes:
¡ To cancel the operation, press [BAND].
When pairing is successfully established, "*** CON-
¡
NECTED" appears. (*** indicates the device name.)
¡ When pairing is not successfully established, "PAIR
ERR" appears.
If 2 minutes elapse before pairing establishment,
¡
"TIME OUT" appears.
PINCODE
The PIN code of the device with which pairing is
established shall be entered. (default: 0000)
Note: This is displayed only when no information about
the connected devices last time exists.
1 Use []], [[], [}] and [{] for PIN code entry.
2 Press [BAND] to determine the entry.
Note: The buttons from [0] to [9] on the remote control
are also available for PIN code entry.
58
CQ-DX200W
/CONNECT
Establishment of pairing with the devices last time
connected
Notes:
¡ This is displayed only when pairing is not established
with the connected devices last time.
*** indicates the device name with connection infor-
¡
mation.
Press [BAND].
Notes:
To cancel the operation, press [BAND].
¡
¡ When pairing is successfully established, "*** CON-
NECTED" appears. (*** indicates the device name.)
¡ If 2 minutes elapse before pairing establishment,
"ERROR" appears.
/DISCONNECT
Cancellation of pairing with the devices currently
connected
Notes:
¡ This is displayed only when pairing is successfully
established.
¡ *** indicates the name of the connected device.
Press [BAND].
Notes:
¡ To cancel the operation, press [BAND].
¡ When pairing is successfully canceled, "*** DISCON-
NECTED" appears. (*** indicates the device name.)
¡ If 2 minutes elapse before pairing cancellation,
"ERROR" appears.
NEW PAIR
Establishment of new pairing
Note: This is displayed only when information about the
connected devices last time exists.
Press [BAND].
DELETE
Deletion of information about the connected device last
time
Note: This is displayed only when information about the
connected devices last time exists.
Press [BAND].
Note: When information is successfully deleted,
"DELETED" appears.