Philips SOPHO SuperVisor 25 Engineer's Manual page 37

have to delete it.
3. Prepare the console by pressing the 'menu key' as depicted here. In the soft key menu
press the button which is under 'comm' on the display. (If required consult
"DIAGRAMS" for a total overview of the soft key menu.)
4. Select 'P-Dial' (only for model 35) and bit rate 19200 bit/s. Press the button which is under
'Return' on the display. Now your Supervisor is ready to accept data from the PC.
5. On the PC, go to the directory in which the tool is installed. Now you can start the tool
without or with file parameters:
Note: It is advised to use the tool without file parameters. It automatically selects the VPU data
files which are in the same directory as the tool.
- Without parameters enter: SVFW200<CR>
The tool will ask for the firmware data files and VPU data files.
Continue with step 6 in this procedure.
- With file parameters.
Enter the name of the tool followed by the file names that you want to upload:
SVFW200 SV_35_v.DWL VPUD01_v.DWL VPUD02_v.DWL VPUD03_v.DWL
VPUD04_v.DWL VPUD05_v.DWL VPUD06_v.DWL VPUD07_v.DWL
VPUD08_v.DWL VPUD09_v.DWL<CR>
('v' in the file names, represents the version number of the file.)
Now the tool starts loading the firmware data files and VPU data files.
You can skip the remaining part of this procedure.
6. The following text is displayed on the screen:
Tool 12nc : 3522 278 42842
Tool version: 1.01
Upload firmware and VPU data
Upload firmware
Give file name:
7. Fill in the file name of the firmware file (SV_35_v. DWL) and close with <CR>. Now the
following text will be displayed on the screen:
Give file name: [C:\<directory>\]SV_35_v.DWL
(If not in the same drive/directory, specify the path.)
Wait for delete completed
A .
35