Wiring Diagram; Power Supply; Electrical Connections - Carrier 42GWC004-3 Installation Manual

42 GW

Electrical connections

The control panel can be reached by opening the grille and
removing the metal covers using the 3 or 4 screws.
Wiring diagram legend
Factory wiring
Field wiring
Connector
Terminal on terminals
Normally closed contact
Normally open contact
Capacitor
FC Fan capacitor
FS Safety switch float
IFM Fan motor indoor unit
PR Drain pump relay
PS Drain pump
C1-3 Connectors
HR Heating relay
CR Cooling relay
CEV Electric valve (cooling)
HEV Electric valve (heating)
PCB Relay board
HTR Electric heater
ST Safety thermostat
T Timer
TB Terminal board
GB - 12
Connect the power cables to terminal box connectors in
accordance with the wiring diagram and tighten firmly.
IMPORTANT:
• Make ground connection prior to any other electrical
connections.
• If the unit is fitted with an electric heater, this must have a
separate power supply.
Ensure that the mains supply connection is made through a
switch that disconnects all poles, with a contact gap of at least
3 mm.
• Fix the power cable of the electric resistance heaters under the
single cable clamp. Make certain that the YELLOW/GREEN
cable is stripped back further than the others.
Low speed
Medium speed
High speed
Power supply line
Heating selection
Common thermostat (heating)
Cooling selection
Common thermostat (cooling)
Neutral fan
Neutral in
Neutral out
Neutral
Heating out
Cooling out
Cables colour
A Brown
B Blue
C Black
G Grey
R Red
W White
Y-G Yellow/Green
Connections
L Line phase
N Neutral
Warning:
Any warranty is declined in case of
field changes of factory wiring and
settings
Note
The connection sequence does not
represent the physical lay-out.