Settings; Programming The Unit With The Tv's Remote Control (Tv's Remote Control Learning Function) - Yamaha SRT-700 Owner's Manual

Settings

Programming the unit with the TV's remote control
(TV's remote control learning function)
Once you program the unit, you can control it with your TV's remote control for functions
such as turning on/off the TV and unit simultaneously, or volume up/down and muting/
unmuting of the unit.
• This function is available only when your TV's remote control uses IR (infrared) signal.
• A radio wave remote control will not work.
• If you want to use a cable or satellite set top box's remote control to operate the unit, use your original
TV's IR (infrared) remote control to program the unit, then use the set top box's remote control to
operate.
• If by changing the volume of the unit the TV's volume also changes, set the TV's volume to minimum, or
disable speaker output.
1
Turn off the TV.
2
Turn off the unit.
3
Hold down the LEARN key on the unit's remote control for more than
3 seconds to set the unit to the learning mode.
When the unit is in the learning mode, the indicators on the front panel flash as
shown below.
NOTE
• Steps 4 to 7 require only the TV's remote control and the keys on the front panel of the unit. The
remote control of the unit is not necessary.
• If the unit has already learned functions, the following indicators light up.
Mute: TV
Volume (–): BD/DVD
Volume (+): ANALOG
Power: BLUETOOTH
4
Teach the unit the "Mute" code of the TV's remote control.
4-1 Press MUTE on the front panel of the unit.
En
12
4-2 While pointing your TV's remote control at the remote control sensor, hold
down the mute key for more than 1 second twice or three times.
Approx. 30 cm (1 ft)
TV's remote control
Hold down Release
(more than 1 second) (more than 1 second)
Result Bleep/buzzer Indicators
Successfully
Once
learned
Failed to learn
* Repeat from Twice
Step 4-1.
5
Teach the unit the "Volume (–)" code of the TV's remote control.
5-1 Press VOLUME (–) on the front panel of the unit.
5-2 While pointing your TV's remote control at the remote control sensor, hold
down the volume (–) key for more than 1 second twice or three times.
Result Bleep/buzzer Indicators
Successfully
Once
learned
Failed to learn
* Repeat from Twice
Step 5-1.
Hold down Release
(more than 1 second) (...)
Lights up
Flash
Lights up
Flash