Remote Control - Yamaha SRT-700 Owner's Manual

No sound is The volume of the subwoofer is
too low.
coming from the
subwoofer.
The playback source does not
contain low-frequency signals.
The volume The automatic volume adjustment
function worked. To prevent
decreases when
excessive loudness, the unit
the unit is turned
automatically controls its volume
on.
within a certain level when the unit
is turned on.
No surround Stereo playback is selected.
effect.
The volume is too low.
The TV or playback device is set
to output 2 channel audio (such
as PCM) only.
The audio is output from the TV
built-in speakers.
The listening position is too close
to the unit.
Noise is heard. The unit is too close to another
digital or high-frequency device.

Remote control

Problem Cause
The unit cannot The unit is out of the operating
be controlled range.
using the remote
The batteries are weak.
control.
The remote control sensor of the
unit is exposed to direct sunlight
or strong lighting.
En
16
Turn up the volume of the subwoofer
(p.8).
Play back a sound source containing
low-frequency signals, and confirm
that the sound is output from the
subwoofer.
If necessary, turn up the volume (p.8).
Select surround playback (p.9).
Turn up the volume (p.8).
Change the digital audio output setting
on the TV or playback device to Dolby
Digital or BitStream.
Set the TV volume to minimum (p.6).
Listen from a position at some
distance from the unit.
Move those devices away from the
unit.
Remedy
Use the remote control within the
operating range (p.2).
Replace with new batteries (p.2).
Adjust the lighting angle, or reposition
the unit.
The unit does The TV's remote control key was
not held down long enough.
not learn TV's
remote control
The TV's remote control does not
operations.
use infrared signals. (Some
remote controls may not work
even if it uses infrared signals.)
The position where you operated
the TV's remote control is not
appropriate.
The batteries of the TV's remote
control are weak.
The remote control sensor of the
unit is exposed to direct sunlight
or strong lighting.
The transmission of the remote
control signal was disturbed by
the TV screen light.
Sound is coming Audio output is enabled on the
TV.
from the TV
when the unit
volume is turned
up with the TV's
remote control.
(when TV's
remote control
learning function
is used)
The power of the The power of the TV was on when
you performed the learning
unit and of the
operation.
TV switch in the
opposite
direction. (For
example, the TV
is turned off if
the unit is turned
on.)
(when TV's
remote control
learning function
is used)
Hold down the key for more than 1
second twice or three times (p.12).
The TV's remote control learning
function cannot be used in this case.
Use the unit's remote control to
operate the unit.
Operate the TV's remote control at the
appropriate position (p.12).
Replace with new batteries.
Adjust the lighting angle, or reposition
the unit.
Turn off the TV and perform the
learning operation again (p.12).
Change the TV setting to disable the
TV speaker output. If a setting to
disable the speaker output is not
available on your TV, try the following
methods.
- Connect headphones to the
headphone jack on the TV.
- Set the TV volume to minimum.
Press the power key on the TV and
(power) on the front panel of the unit to
turn them on and then press the power
key on the TV's remote control to turn
them off.