Remington IPL4000 Manual page 12

(fig. 1-G)
Light Cartridge
Each light cartridge has a life of 1,500 flashes. When all flashes have been used, the
cartridge must be replaced.
Replacement model: SP-IPL
Intensity Level Selection
The i-Light device is equipped with 5 intensity levels. Level 1 is the lowest setting and level
5 is the highest setting.
TIP: For the most effective results, always use the highest intensity level that does
not cause discomfort on the skin. To determine the intensity level being used,
observe the number of lights illuminated on the Intensity Level Selection
Display.
Your i-Light device will automatically be set to Intensity Level 1 each time the device is pow-
ered ON. To change the level, press the Intensity Level Selection Button.
Flash Mode Selection
The i-Light device is equipped with two operating modes: Single Flash Mode and Multi-
Flash Mode. Your i-Light device will automatically be set to Single Flash Mode each time
the device is powered ON.
Single Flash Mode: The i-Light device will flash once when the Flash Button is
pressed AND the skin contact sensor is engaged.
Multi-Flash Mode: The i-Light device will flash once every two seconds when the
Flash Button is pressed AND the skin contact sensor is fully engaged.
The Multi-Flash Mode allows you to quickly treat large areas such as the legs, chest or
back by simply gliding the hand piece to a new location after each flash.
To turn Multi-Flash Mode ON, press the Multi-Flash Mode Selector Button. The Multi-
Flash Mode Selector Display will illuminate. Press again to turn Multi-Flash Mode OFF
and return to Single-Flash Mode.
090597_REM_IFU_IPL5000_7L GB11 090597_REM_IFU_IPL5000_7L GB11
(fig. 1-L)
(fig. 1-N)
11
23.07.09 22:03 23.07.09 22:03