Table of Contents
Advertisement
Care: Wipe down the base station, the charging cradle and the handset with a damp cloth (no solvents) or an antistatic
cloth. Never use a dry cloth. This can cause static.
Please note:
◆
Never expose the telephone to the influence of heat sources, direct sunlight or other electrical devices.
◆
Protect your Gigaset from moisture, dust, corrosive liquids and vapours.
Connecting the base station
¤
First connect the mains adapter
¤
Then connect the telephone jack
cables into the cable ducts.
Please note:
◆
The mains adapter must always be connected, as the
phone will not operate without mains connection.
◆
Only use the mains adapter and phone cord supplied.
Pin connections on telephone cables can vary.
Connecting the charging cradle (if included)
2
Setting up the handset for use
The display is protected by a plastic film. Please remove the protective film!
Inserting the batteries and closing the battery cover
Warning
Use only the rechargeable batteries recommended by Gigaset Communications GmbH (
conventional (non-rechargeable) batteries as this could result in significant health risks and personal injury. For
example, the batteries could explode. The phone could also malfunction or be damaged as a result of using batter-
ies that are not of the recommended type.
¤
Insert the batteries
with the polarity in the
correct direction.
The polarity is indicated in
the battery compartment.
1
.
2
and insert the
¤
Connect the flat plug from the power
1
supply
.
¤
Plug the mains adapter into the plug
1
2
socket
.
If you need to disconnect the plug from the
charging cradle, press the release button
and disconnect the plug
¤
Insert the battery cover from
the top.
¤
Then slide the cover upwards
until it clicks into place.
3
2
1
4
.
To open the battery cover, for instance to
replace the batteries:
¤
Reach into the notch at the top of the
cover and slide the cover down-
wards.
1
1
4
3
3
¢
page 13), i.e., never use
Advertisement
Table of Contents
