Sony SAL1118 Service Manual page 50

4-6-2. Zoom Brush Position Adjustment and Pattern Check
Equipment
• Personal Computer (PC)
• Camera DSLR-A100
• USB Cord With Connector
• Adhesive Bond (B-10)
• Lens Adjustment Program
Note: Lens Adjustment Program is downloadable from the ESI homepage.
1. Preparations
1) Remove the zoom lens and brush cover.
2. Zoom Brush Position Adjustment
1) Set the zoom position to Tele end.
2) Perform the "4-6-1. Zoom Brush Position Check", and adjustment to Brush Position until the OK (Green) indicator of "Position"
lights, and fixed with the double-faced tape after adjusting.
3. Pattern Check
Note: When the NG (Red) indicator of "Position" lights during checking, does not care about it (It is normal performance).
1) Turn the zoom ring slowly from the Wide end "Zoom Pattern : 1" to Tele end "Zoom Pattern : 20" and check that the value of "Zoom
Pattern" change from 1 to 20 continuously.
2) Turn the zoom ring slowly from Tele end (Zoom Pattern : 20) to the Wide end (Zoom Pattern : 1) and check that the value of "Zoom
Pattern" change from 20 to 1 continuously.
[Exit]
3) Click the
[End]
4) Click the
5) Turn the POWER switch of the camera to OFF.
SAL1118 (4.5-5.6/11-18) (DT 11-18mm F4.5-5.6)
Fig. 4-6-5
button.
button to terminate the lens adjustment program.
h h h
h h
Fig. 4-6-6
4-19