Table of Contents
Advertisement
• As the ambient temperature is low (10oC
or less), the performance of the batteries
will be deteriorated and the available
recording/playback time becomes
extremely short. This is normal. Alkaline
batteries significantly show such
tendencies. In such cases, remove the
batteries and warm them in your pocket.
Take special care not to allow the contacts
to come into contact with metal objects or
a pocket warmer in your pocket.
• If an oil stain or any foreign substance is
found on the battery contacts, it could
prevent the batteries from making good
electrical contact. The available recording/
playback time may become extremely
short. Before inserting the batteries, clean
the battery contacts with soft, dry cloth.
If any leakage from the batteries is noted,
remove the batteries, thoroughly wipe off
the battery electrolyte in the battery
housing and then insert new batteries or
fully charged Ni-MH batteries.
If leaked battery electrolyte contacts your
hand or cloth, wash with water. Battery
electrolyte may cause loss of sight if it
comes in contact with your eyes. In such
cases, do not rub at your eyes.
Immediately wash your eyes with pure
water and consult a doctor.
14
VQT0Q78
Preparation
∫ Ni-MH Batteries (Nickel Metal Hydride)
Ni-MH batteries can be used when you
charge them with the exclusive charger.
However, wrong handling of the batteries
may cause leakage, generation of heat, fire
or explosion. Please be aware of the
following issues:
• If any oxidation or foreign substance is
found on the battery contacts, the
batteries may not be charged correctly.
Clean battery contacts and terminals of
the recharger with a soft, dry cloth.
• Newly purchased Ni-MH batteries or
those which have not been used for a long
period of time may not reach full capacity
after one charge. This is a feature of the
batteries, not a malfunction. The overall
performance will increase after repeating
discharge/charge cycles several times.
• Batteries should be used to the point
when the camera stops working before
recharging. If you charge batteries without
discharging enough, it can cause
"memory effect", whereby the overall
operating time can be decreased.
• If "memory effect" occur, use the batteries
until the camera stops working and then
recharge them fully. Repeat the discharge/
charge cycles several times. The capacity
of the batteries will be recovered.
• Ni-MH batteries will naturally discharge
and the capacity will become lower even if
they are not in use.
• Once Ni-MH batteries have reached full
charge, do not charge them continuously.
• Do not peel off or scratch the covered
seal.
• Read the operating instructions for the
battery charger.
Ni-MH batteries have a limited life. The
capacity of the batteries decreases
gradually over time. If available time seems
much shorter, the battery life may be
expired. Purchase new batteries.
Advertisement
Table of Contents
