Connecting To Other Basecam Sbgc Based Gimbal - S.bus - ACR Systems LINK User Manual

CONNECTING TO OTHER BASECAM SBGC BASED GIMBAL – S.BUS
To connect The Link with BaseCam SBGC based gimbal with S.BUS you should take the following
steps:

Plug one end short servo cable 3-to-3 to your gimbal signal socket so it will correspond with
GROUND, VOLTAGE and SIGNAL on The Link

Plug other side of this cable to The Link client unit to the pin 6 (S.Bus) – brown cable to the
top.

Attach The Link client unit to vertical arm of BaseCam SBGC based gimbal.

Turn on the gimbal.

In The Link client menu choose BaseCam SBGC S.BUS defaults.

BaseCam SBGC select as follow:
o
ROLL -> RC_VIRT_CH_1
o
PITCH -> RC_VIRT_CH_2
o
YAW -> RC_VIRT_CH_3
www.acr-sys.com
THE LINK - MANUAL
Page: 17