Connecting To Acr The Beast - ACR Systems LINK User Manual

CONNECTING TO ACR TH E BEAST
To connect ACR The Link with ACR The Beast you should take the following steps:

Plug one end of both short servo cables 3-to-3 to The Beast REMOTE socket – brown cables
to the bottom.

Plug other side of those cables to The Link as follow:
o
Bottom cable connect vertically on pin 1 – brown cable to the top.
o
Top cable connect horizontally on bottom pins 2, 3 ,4 starting from brown cable.

Attach The Link client unit to vertical arm of ACR The Beast.

Turn on The Beast and toggle ON The Link in CONTROL -> ADVANCED.

For best performance in CONTROL menu set as follow

Expo rate – 0%

Deadband – 3%

Filter – 6,2%

Roll/Tilt/Pan speed – 100%

In The Link client menu choose The Beast profile.
www.acr-sys.com
THE LINK - MANUAL
Page: 14