Connecting To Other Basecam Sbgc Based Gimbal - Pwm - ACR Systems LINK User Manual

CONNECTING TO OTHER BASECAM SBGC BASED GIMBAL – PWM
To connect The Link with BaseCam SBGC based gimbal with PWM you should take the following
steps:

Plug one end of both short servo cables 3-to-3 to your gimbal signal socket.

Plug other side of those cables to ACR The Link as follow:
o
Bottom cable connect vertically on pin 1 – brown cable to the top.
o
Top cable connect horizontally on bottom pins 2, 3 ,4 starting from brown cable.

Attach The Link client unit to vertical arm of BaseCam SBGC based gimbal.

Turn on the gimbal.

In The Link client menu choose BaseCam SBGC defaults.

In ACR Manager select The Link in Default RCU, in other BaseCam SBGC select as follow:
o
ROLL -> RC_ROLL – PWM
o
PITCH -> FC_PITCH – PWM
o
YAW -> FC_ROLL – PWM
www.acr-sys.com
THE LINK - MANUAL
Page: 16