Advertisement
Operation
Air flow direction
Point the transmitter towards the receiver kit and press "LO-
UVER" switch to set the louver angle.
COOL
The louver angle is set to 1 step
at "Hi" in the cooling operation.
By pressing "LOUVER" switch, the louver angle will be changed
as follows.
Step
LCD indication
-
1
2
3
4
5
6
7
5.4 AUTOMATIC COOLING/HEATING OPERATION
This function is only available for DC Inverter UTOPIA series (single combination) and SET-FREE series (heat recovery system).
7
PMML0314A rev.0 - 09/2013 - P5415315
Hi
°C
COOL, DRY
HEAT, FAN
Auto-swing
Recommended
angle
Angle range
Angle range
Recommended
angle
: Auto swing operation will be started. At this time, the louver
will swing repeatedly on LCD.
N O T E
•
The louver angle is not displayed during the stoppage.
•
The louver setting are only available from 1 step through 5
step and auto swing at the cooling and dry operation modes.
•
The louver angle may be changed automatically during the
heating operation. (Refer to the installation and operation ma-
nual of indoor unit about detail.)
•
The louver may NOT stop immediately right after the switch
is pressed.
•
The auto louver mechanism is not available for In-the-Ceiling
type.
Advertisement
