Advertisement
Installation
4 INSTALLATION
D A N G E R
•
Turn OFF the power source completely before perfor-
ming the dip switch setting, installation work and elec-
trical wiring work for receiver kit. If not, it may cause an
electric shock.
•
Perform securely the installation work referring to this
installation manual. If the installation is not completed, it
may cause injury by falling down the receiver kit.
•
Do not install the receiver kit where the flammable gases
may generate or enter. It may cause heat generation or
a fire.
•
Perform securely the electrical wiring work. If the electri-
cal work is not completed, heat generation at the connec-
tion, a fire or an electric shock may occur.
•
Make sure that the electrical wires are securely fixed in
order not to apply an external force to the terminal con-
nections of the wirings. If fixing is not completed, it may
cause heat generation or a fire.
1 Perform the installation work for receiver kit while the indoor unit is being mounted.
2 Be sure to turn OFF the power source of indoor unit when the receiver kit is attached after the indoor unit is mounted.
3 Remove the right side cover.
a. Open the air inlet grille.
Air inlet Grille
c. Push the side cover to 15mm forward to remove the hooks and the hooking plate.
d. Remove the side cover to lift upward.
4 Remove the remote control switch cover attaching to the lower cover.
a. Insert screwdriver or a stick (maximum f5) into the service hole at the lower right side of lower cover.
3
PMML0314A rev.0 - 09/2013 - P5415315
•
When the receiver kit is attached near lighting which gene-
rates the ambient light, it may not receive the signal from the
wireless remote control. Pay attention to the installation posi-
tion of receiver kit.
•
Do not run the wire for receiver kit and wire of 220-240V
(power source wire) in parallel. It may cause malfunction of
receiver kit by noise.
Position for Fixing Screw
Hooking Plate
Hooks (3 portions)
C A U T I O N
b. Remove the fixing screw (M4)
Fixing Screw
Advertisement
