Awning Installation; Tools Needed; Identification Of Key Parts (Figure 1) - SunSetter 1000XT Owner's Manual & Installation Instructions

Note: The Awning size (width) is measured from the outside of the Arms. See Figure 1.
WARNING: FAILURE TO WEAR SAFETY GLASSES OR TO FOLLOW THE INSTRUCTIONS BELOW COULD RESULT IN
PERSONAL INJURY!
WARNING: THE SUNSETTER AWNING MUST BE USED WITH THE FABRIC FULLY EXTENDED AND BOTH
RAFTERS LOCKED IN THE 'UP' POSITION AS SHOWN IN FIGURE 1. BE SURE TO READ THE HOMEOWNER'S
OPERATION AND MAINTENANCE MANUAL THAT IS INCLUDED WITH YOUR AWNING.
WARNING: NEVER ATTEMPT TO REPAIR OR DISASSEMBLE ANY PART OF THE AWNING WITHOUT FOLLOWING
REPLACEMENT PART PROCEDURES SUPPLIED BY THE MANUFACTURER. TRYING TO DO SO WITHOUT PROPER
INSTRUCTIONS COULD RESULT IN PERSONAL INJURY.
1. Before starting, you will need: An Assistant, Hammer, Measuring Tape, Step Ladder, Two Chairs or Saw
Horses, Electric Drill and Drill Bits: 1/8", 3/16", 9/32", 5/8", Level, Pencil, Punch, Knife or Scissors, Pliers, Socket and
Driver: 3/8", Wrench: 7/16", Phillips Screwdriver, and Flat Screwdriver.
For Masonry installation and Concrete patio: Masonry Drill Bits: 1/4", 5/16", 1/2", and 5/8" and a 1" x 4" Pressure
Treated Header Board equal to the width of your Awning.
2. See Figure 1 for Identification of Key Parts mentioned in the instructions.
Roller Bar
Valance
Figure 1 - Identification of Key Parts

AWNING INSTALLATION

Tools Needed:

Crank Loop
Drive Unit
Left Wall Bracket
Lift Handle
Awning Rail
Fabric
Outer Arm
Right Wall Bracket
Inner Arm
Ground Bracket
(Secured to Deck Plate)
Deck Plate
1
Upper Bracket
Rafter Lock Latch
Rafter