Graco 334530D Operation And Parts Manual page 32

Troubleshooting
Problem
Sprayer does not run at all
AND
Display is blank
OR
Control board status light never lights
Sprayer does not shut off
AND
Displays Code 02 message
OR
Control board status light blinks 2
times repeatedly
Sprayer does not run at all
AND
Displays Code 02 message
OR
Control board status light blinks 2
times repeatedly
32
What to Check
See flow chart, page 37.
Control board.
Check transducer or transducer
connections
How to check
Replace control board.
Make sure there is no pressure in the
system (see Pressure Relief
Procedure, page 13). Check fluid
path for clogs, such as clogged filter.
Use airless paint spray hose with no
metal braid. A small hose or metal
braid hose may result in
high-pressure spikes.
Turn ON/OFF switch OFF and
disconnect power to sprayer.
Check transducer and connections to
control board.
Disconnect transducer from control
board socket. Check that transducer
and control board contacts are clean
and secure.
Reconnect transducer to control
board socket. Connect power, turn
ON/OFF switch ON and control knob
1/2 turn clockwise. If sprayer does not
run properly, turn ON/OFF switch
OFF and go to next step.
Install new transducer. Connect
power, turn ON/OFF switch ON and
control knob 1/2 turn clockwise.
Replace control board if sprayer does
not run properly.
334530D