Lighting Instructions - Napoleon L485 User Manual

Lighting Instructions

Lights Left Burner
WARNING!
Open lid.
WARNING!
Ensure all burner controls are in the off position. Turn on the gas supply
valve.
Main Tube Burner
Lighting
1. Open grill lid.
2. Push and turn any main burner
knob slowly to the 'hi' position. This
action will ignite the pilot flame
which will in turn light the selected
burner. If the pilot lights, continue to
push down on the control knob until
the burner lights and then release.
3. If the pilot does not ignite, then
immediately turn the control knob
back to the 'off position and repeat
step 2 several times.
4. If the pilot and burner will not
ignite within 5 seconds, turn the
control knob to the 'off' position and
wait 5 minutes for any excess gas to
dissipate. Either repeat steps 2 and 3
or light with a match.
5. If lighting the unit with a match,
clip the match into the supplied
lighting rod. Hold the lit match down
through the grill and sear plate while
turning the corresponding burner
valve to high.
WARNING!
The propane cylinder is equipped with an excess flow device. Unless all burners are
turned off prior to turning the cylinder on, only small flames and low heat will be achievable.
WARNING!
Do not use the rear burner (rotisserie burner) with the main burners operating.
Rear Burner Centre Burner Right Burner
Rear Burner Lighting
(If equipped)
1. Open grill lid.
2. Remove the warming rack
3. Clip a match into the supplied
lighting rod. Hold a lit match to
right end ports of rear burner.
Turn rear burner to high.
Side Burner
Side Burner Igniter
Off Position
Side Burner Lighting
(If equipped)
1. Open/Remove side burner cover.
2. Push and turn side burner control
to high position.
3. Press and hold igniter button until
burner lights, or light by match
4. If the burner will not ignite within
5 seconds, turn the control knob to
the 'off' position and wait 5 minutes
for any excess gas to dissipate. Either
repeat steps 2 and 3 or light with a
match.
www.napoleongrills.com
7
EN