Installation Precautions - Panasonic AW-RC400E Operating Instructions Manual

Indoor Pan/Tilt Head AW-PH400

Installation precautions

≥ Do not install the unit on any of its sides.
≥ Avoid using the unit in the kitchen and other locations with lots of steam and oily vapors.
≥ Mount the camera on the pan/tilt head only when you have finished installing it.
≥ The maximum load-bearing capacity of this unit is 8 kg.
It cannot be used if the load to be borne exceeds 8 kg.
≥ Do not use a lens which will impair or upset the unit's balance.
Even if the load borne by the unit is less than 8 kg, it cannot be used if the unit will be set off-balance by the lens mounted on
it.
≥ Do not install the unit outdoors or in places where the temperature will be hotter than 45°C or colder than 0°C.
Use the unit in places where the humidity is below 90%.
≥ Purchase the mounting screws separately since they are not supplied with the unit.
≥ Do not hold or lift the unit by its rotating part. Doing so may cause malfunctioning.
≥ Do not turn the unit's rotating part by hand. Doing so may cause malfunctioning.
≥ Dropping the unit or subjecting it to strong impact may give rise to malfunctioning.
≥ Leave a clearance of at least 1 meter from around the monitor when installing the unit.
≥ When mounting the camera on the unit, take sufficient steps to ensure that it will not become detached from the unit or fall
onto the floor.
≥ Install the unit in such a way that the equipment mounted on it and its cables will not come into contact with anything when the
pan/tilt head swivels, and set definite movement limits.
5 (E)