Operating In 110V Or 220V - Vista Spyder 200 Series Operation Manual

Operating in 110V or 220V
Spyder™ ships in the setting predetermined by where it is shipping to be ready for operation out
of the box. It comes with a sticker over the AC inlet noting if it is set for 110V or 220V. If
operating with a voltage other than what it is set for, a few changes need to be made.
To change from 110V to 220V:
1. Pull the fuse holder (See figure 1.1.2) from the AC inlet (See figure 1.1.3).
2. Pull the jumper and current fuse from the fuse holder.
3. Add fuses included with shipping kit (2‐3A fuses for 3RU or 2‐2A fuses for 2RU). One on
each side of the fuse holder.
4. Insert fuse holder back into the AC inlet and power up. You are now set for 220V.
To change from 220V to 110V:
1. Pull the fuse holder (See figure 1.1.2) from the AC inlet (See figure 1.1.3).
2. Pull both fuses from the fuse holder
3. Add jumper (See figure 1.1.1) on one side of fuse holder and fuse on the other side that
is included with shipping kit (1‐5A fuse for 3RU or 1‐3A fuse for 2RU).
4. Insert fuse holder back into the AC inlet and power up. You are now set for 110V.
7