Bridged/Routed Configuration: Pppoe Routed Example - LG LDK24 ADSL Router User Manual

g. From here, you can configure the one WAN protocol of 3.3 Routed configuration you
want as well as IPoA The configuration of IPoA in this section is similar to the IPoA
routing setup in Ethernet - IPoA routed. Refer to the 3.3 Routed configurations : 3.3.1
Ethernet - IPoA routed about detailed configuration.

Bridged/Routed configuration: PPPoE routed example

B.2.3
For this configuration, you need to attach the Ethernet devices called ethernet and usb-ethernet
to the bridge. If you want to change default LAN IP address, refer to Annex C : Changing default
LAN IP address.
You can set "Bridged/Routed configuration" by following instructions.
a. From the left-hand menu, click on Configuration>WAN connections.
Refer to the figure-5
b. The WAN connections page is displayed. If there are any connections listed, click on the
Delete hyperlink, then click on Delete this connection. Repeat until all WAN
connections have been deleted. Refer to figure-7
c. From the left-hand menu, click on Configuration>IP routes. If there are any routes
listed, check the Delete? checkbox and click on Apply. Repeat until all IP routes have
been deleted. Refer to the figure-8
d. From the Status page, click on the LAN Settings hyperlink or from the left-hand menu,
LDK24 ADSL Router User's Manual
Version 1.0D
<figure -usb4>
Copyright© 2002 LG Electronics Inc., LTD.
Page 59 of 67