Ethernet - Pppoe Routed; The Wan Connections Page Is Displayed. If There Are Any Connections Listed, Click On The - LG LDK24 ADSL Router User Manual

3.3.4 Ethernet – PPPoE routed
You can set "PPPoE routed(PPPoE)" by following instructions.
a. From the left-hand menu, click on Configuration>WAN connections
Refer to the figure-5.
b. When you click on Configuration>WAN connections., if asking for username and
password, type username "admin" and password "admin".
Refer to the figure-6.
c. The WAN connections page is displayed. If there are any connections listed, click on the
Delete hyperlink, then click on Delete this connection. Repeat until all WAN
connections have been deleted like the picture below.
Refer to the figure-7.
From the left-hand menu, click on Configuration>IP routes. If there are any routes
d.
listed, check the Delete? checkbox and click on Apply. Repeat until all IP routes have
been deleted.
Refer to the figure-8.
From the left-hand menu, click on Configuration>WAN connections. Click on Create a
e.
new service.
Refer to the figure-9.
f. Click on the PPPoE routed radio button, then click on Configure. At the WAN
connection: PPPoE routed page, complete the following:
Description: pppoe-routed : arbitrary name
VPI: 0(for example)
VCI: 32(for example)
CHAP or PAP(click radio button) : this value is determined by service provider
User name: vdsobod : this value is assigned by service provider
Password: ldk24p : this value is assigned by service provider
You do not need to make changes to the other default settings. Click on Apply. The WAN
connections page is displayed, containing details of the new PPPoE transport. By default,
the PPPoE connection uses interface ID 1.
LDK24 ADSL Router User's Manual
Version 1.0D
Copyright© 2002 LG Electronics Inc., LTD.
Page 25 of 67