Ethernet - Rfc1483/Rfc2684 Routed; Refer To The Figure-5 - LG LDK24 ADSL Router User Manual

3.3.2 Ethernet – RFC1483/RFC2684 routed
You can set "RFC1483/RFC2684 routed mode" by following instructions.
a. From the left-hand menu, click on Configuration>WAN connections

Refer to the figure-5.

b. When you click on Configuration>WAN connections., if asking for username and
password, type username "admin" and password "admin".
Refer to the figure-6.
c. The WAN connections page is displayed. If there are any connections listed, click on the
Delete hyperlink, then click on Delete this connection. Repeat until all WAN
connections have been deleted like the picture below.
Refer to the figure-7.
d. From the left-hand menu, click on Configuration>IP routes. If there are any routes
listed, check the Delete? checkbox and click on Apply. Repeat until all IP routes have
been deleted.
Refer to the figure-8.
e. From the left-hand menu, click on Configuration>WAN connections. Click on Create a
new service.
Refer to the figure-9.
f. Click on the RFC 1483 routed radio button, then click on Configure. At the WAN
connection: RFC 1483 routed page, complete the following:
Description: rfc1483-routed : arbitrary name
LDK24 ADSL Router User's Manual
Version 1.0D
<figure -12>
Copyright© 2002 LG Electronics Inc., LTD.
Page 21 of 67