Card Configuration; Figure 9 Slot Distribution In Subscriber Shelf - Zte FSAP 9800 Technical Manual

FSAP 9800 Technical Manual
Methods
Slot Distribution
in Subscriber Shelf
24 Confidential and Proprietary Information of ZTE CORPORATION

Card Configuration

The following are methods of configuring shelves:
� Configure the subscriber shelf and splitter shelf in one cabinet,
implementing the access of broadband data service and nar-
rowband voice service at the same time.
� Configure the subscriber shelf only. The subscriber shelf holds
subscriber cards with built-in splitters, implementing the ac-
cess of broadband data service and narrowband voice service
at the same time.
� Configure the subscriber shelf only. The subscriber shelf holds
subscriber cards without built-in splitters, implementing the
access of pure narrowband voice service.
� Configure the subscriber shelf only. The subscriber shelf holds
subscriber cards without built-in splitters and splitter cards to-
gether, implementing the access of broadband data service and
narrowband voice service at the same time.
Figure 9 shows the slot distribution in an FSAP 9800 subscriber
shelf using the MDCA/MDCE backplane. MDCF backplane works
with the CSCA/CSCE/CSCT/CSCM control and switching card.
F 9 S D
IGURE LOT ISTRIBUTION IN
MDCA/MDCE B
ACKPLANE
Note:
When the MDCA/MDCE backplane is used, the Ethernet interface
card supports EINB2 and does not support EINB4 or EINT.
Figure 10 shows the slot distribution in an FSAP 9800 subscriber
shelf using the MDCF backplane. MDCF backplane works with the
MSCT/MSCX control and switching card.
S S
UBSCRIBER
)
(U
HELF SING