Step
7.
Redistribute VPN routes.
8.
(Optional.) Configure a
filtering policy to filter the
routes to be advertised.
9.
(Optional.) Configure a
filtering policy to filter the
received routes.
NOTE:
IPv6 BGP runs within a VPN in the same way as it runs within a public network. For more information
about IPv6 BGP, see
Displaying information about IPv6 MCE
Execute display commands in any view.
Task
Display information about a specific or all VPN
instances.
Display BGP peer group information for a VPN
instance.
Display BGP peer information for a VPN
instance.
For commands that display information about a routing table, see Layer 3—IP Routing Command
Reference.
IPv6 MCE configuration example
Network requirements
As shown in
VPN 2 through VLAN-interface 20. RIPng is used in VPN 2.
Configure the IPv6 MCE to separate routes from different VPNs and advertise VPN routes to PE 1 through
OSPFv3.
Command
import-route protocol [ process-id [ med
med-value | route-policy
route-policy-name ] * ]
filter-policy { acl6-number | prefix-list
ip-prefix-name } export [ direct | isisv6
process-id | ospfv3 process-id | ripng
process-id | static ]
filter-policy { acl6-number | ipv6-prefix
ip-prefix-name } import
Layer 3—IP Routing Configuration Guide
Figure
6, the IPv6 MCE device is connected to VPN 1 through VLAN-interface 10 and to
.
Command
display ip vpn-instance [ instance-name
vpn-instance-name ]
display bgp group ipv6 vpn-instance vpn-instance-name
[ group-name ]
display bgp peer ipv6 vpn-instance vpn-instance-name
[ group-name log-info | ipv6-address { log-info | verbose }
| verbose ]
35
Remarks
By default, no route
redistribution is configured.
By default, BGP does not filter
the routes to be advertised.
By default, BGP does not filter
the received routes.