Configuring Routing Between An Ipv6 Mce And A Pe - H3C S5820V2H Configuration Manual

Table of Contents

Advertisement

NOTE:
After you configure an IPv6 BGP VPN instance, the IPv6 BGP route exchange for the IPv6 VPN
instance is the same as the normal IPv6 BGP VPN route exchange. For more information about IPv6
BGP, see
2.
Configure the VPN site:
Step
1.
Enter system view.
2.
Enter BGP view.
3.
Configure the MCE as the
EBGP peer.
4.
Create and enter BGP IPv6
unicast instance view.
5.
Enable BGP to exchange
IPv6 unicast routing
information with the EBGP
peer.
6.
(Optional.) Redistribute the
IGP routes of the VPN.

Configuring routing between an IPv6 MCE and a PE

IPv6 MCE-PE routing configuration includes these tasks:
Bind the IPv6 MCE-PE interfaces to IPv6 VPN instances
Perform routing configurations
Redistribute IPv6 VPN routes into the routing protocol running between the IPv6 MCE and the PE.
Configurations in this section are performed on the MCE. For information about configuring the PE, see
the configuration guide for the PE.
Configuring IPv6 static routing between an IPv6 MCE and a PE
Step
1.
Enter system view.
2.
Configure IPv6 static
routes for an IPv6 VPN
instance.
Layer 3—IP Routing Configuration Guide
Command
system-view
ipv6 route-static vpn-instance s-vpn-instance-name
ipv6-address prefix-length { interface-type
interface-number [ next-hop-address ] |
nexthop-address [ public ] | vpn-instance
d-vpn-instance-name nexthop-address }
[ permanent ] [ preference preference-value ] [ tag
tag-value ] [ description description-text ]
.
Command
system-view
bgp as-number
peer ipv6-address as-number
as-number
ipv6-family [ unicast ]
peer ipv6-address enable
import-route protocol
[ process-id [ med med-value |
route-policy route-policy-name ]
* ]
32
Remarks
N/A
N/A
By default, no BGP peer is
configured.
N/A
By default, BGP cannot
exchange IPv6 unicast routing
information with a peer.
By default, no route redistribution
is configured.
A VPN site must advertise the
IPv6 VPN network addresses it
can reach to the connected IPv6
MCE.
Remarks
N/A
By default, no IPv6 static
route is configured.

Advertisement

Table of Contents
loading

This manual is also suitable for:

S5830v2

Table of Contents