H3C S5820V2H Configuration Manual page 40

Step
3. (Optional.) Configure
the default precedence
for IPv6 static routes.
Configuring RIPng between an IPv6 MCE and a PE
Step
1. Enter system view.
2. Create a RIPng process for
an IPv6 VPN instance and
enter RIPng view.
3. Redistribute the VPN
routes.
4. (Optional.) Configure the
default cost value for the
redistributed routes.
5. Return to system view.
6. Enter interface view.
7. Enable the RIPng process
on the interface.
For more information about RIPng, see Layer 3—IP Routing Configuration Guide.
Configuring OSPFv3 between an IPv6 MCE and a PE
Step
1. Enter system view.
2. Create an OSPFv3
process for an IPv6 VPN
instance and enter
OSPFv3 view.
3. Set the router ID.
4. Redistribute the VPN
routes.
5. (Optional.) Configure a
filtering policy to filter the
redistributed routes.
6. Return to system view.
7. Enter interface view.
8. Enable the OSPFv3
process on the interface.
Command
ipv6 route-static default-preference
default-preference-value
Command
system-view
ripng [ process-id ] vpn-instance
vpn-instance-name
import-route protocol [ process-id ]
[ allow-ibgp ] [ cost cost | route-policy
route-policy-name ] *
default cost value
quit
interface interface-type interface-number
ripng process-id enable
Command
system-view
ospfv3 [ process-id ] vpn-instance
vpn-instance-name
router-id router-id
import-route protocol [ process-id |
allow-ibgp ] [ cost value | route-policy
route-policy-name | type type ] *
filter-policy { acl6-number | ipv6-prefix
ipv6-prefix-name } export [ bgp4+ |
direct | isisv6 process-id | ospfv3
process-id | ripng process-id | static ]
quit
interface interface-type
interface-number
ospfv3 process-id area area-id
[ instance instance-id ]
33
Remarks
If you do not specify a
default preference
value, the default
preference value is 60.
Remarks
N/A
N/A
By default, no route of any
other routing protocol is
redistributed into RIPng.
If you do not specify a default
cost, the default cost is 0.
N/A
N/A
By default, RIPng is disabled
on an interface.
Remarks
N/A
N/A
N/A
By default, no route of any other
routing protocol is redistributed
into OSPFv3.
By default, redistributed routes
are not filtered.
N/A
N/A
By default, OSPFv3 is disabled
on an interface.