Integra DRX-7 Basic Manual page 8

Table of Contents

Advertisement

> Before start
> Hookup
Speaker combinations
In any of the combinations, up to two powered subwoofers can be connected.
Speaker
FRONT
Channels
2.1 ch
3.1 ch
4.1 ch
5.1 ch
6.1 ch
7.1 ch
2.1.2 ch
3.1.2 ch
4.1.2 ch
5.1.2 ch
6.1.2 ch
7.1.2 ch
4.1.4 ch
5.1.4 ch
6.1.4 ch
7.1.4 ch
Points to note with speaker combinations
* 1: It is not possible to use Bi-AMP and ZONE speakers at the same time. However, with 2.1 ch to 7.1 ch,
it is possible to use Bi-AMP and ZONE 2 speakers at the same time.
* 2: If you have not connected ZONE 3 speakers in another room but have only connected ZONE 2
speakers, connect the ZONE 2 speakers to the HEIGHT 1 jacks. However, if Bi-Amping connections
are used for front speakers, connect the ZONE 2 speakers to the HEIGHT 2 jacks.
* 3: If front speakers are to be Bi-Amping connected, height speakers need to be connected to the
HEIGHT 2 jacks.
* 4: ZONE 2 speakers need to be connected to the HEIGHT 1 jack, ZONE 3 speakers need to be
connected to the SURROUND BACK jacks, and height speakers need to be connected to the
HEIGHT 2 jacks.
* 5: This unit consists of a 9 ch amplifier, so when using a Bi-Amping connection for the front speakers,
use an RCA cable to connect the power amplifier to the PRE OUT HEIGHT 2 jacks, then connect the
height speakers to the power amplifier.
* 6: This unit consists of a 9 ch amplifier, so with this combination use an RCA cable to connect the power
amplifier to the PRE OUT BACK jacks, then connect the surround back speakers to the power amplifier.
8
> Setup
SURROUND
CENTER
SURROUND
> Playback
> Part Names
HEIGHT 1
HEIGHT 2
BACK
* 3
* 3
* 3
* 3
* 5
* 5
* 6
* 6
HEIGHT 1/HEIGHT 2
When connecting 2 sets of height speakers, the height speaker combinations you can choose are as follows.
– Height 1 Speaker: Top Middle, Height 2 Speaker: Rear High
– Height 1 Speaker: Front High, Height 2 Speaker: One of Rear High/Top Middle/Top Rear/Dolby Enabled
Speaker (Surround)/Dolby Enabled Speaker (Surround Back)
– Height 1 Speaker: Top Front or Dolby Enabled Speaker (Front), Height 2 Speaker: One of Rear High/Top
Rear/Dolby Enabled Speaker (Surround)/Dolby Enabled Speaker (Surround Back)
When connecting only one set of height speakers, select one type of height speakers from the types
available.
ZONE 2
* 1
ZONE 3
Bi-AMP
* 1
(
P18)
* 2
* 2
* 1
(
P19)
* 4
* 4
* 4
* 4

Advertisement

Table of Contents
loading

This manual is also suitable for:

Drx-r1

Table of Contents