Speaker Settings - Technics SC-HDV600 Operating Instructions Manual

1
4
7
SUB TITLE AUDIO
TOP MENU
SETUP
DISPLAY
DVD/CD TAPE
SKIP
SHIFT
A
SETUP
Exit
Test
signal
SELECT
ENTER RETURN
Surround speakers
B
United Kingdom only
SETUP
SELECT
ENTER RETURN
Example: Left surround speaker (LS)
Yes (large)
LS
44
RQT5941
CLOCK/
SLEEP TIMER CANCEL
CANCEL
2 3
≥10/-/--
5 6
8 9 0
ANGLE
MENU
ENTER
w
ENTER
RETURN
EXT TUNER
AUTO/MONO
SLOW/SEARCH
A-B REPEAT
MUTING PLAY MODE
REPEAT
Subwoofer
Center speaker
C
L R
ms dB
O O
Exit
dB
SW
Test O
dB ms dB
LS RS
O O O
(LS) (RS)
L
R
Exit
dB
SW
Test O
Icon
Yes (small) No
LS
Settings

Speaker settings

A
Refer to "Changing the settings" (\ page 41).
For the United Kingdom
Do these settings if you connect center and surround speakers.
For others
You can enjoy multi-channel audio from DVDs without doing these
settings. Change them to improve the effect or when you connect a
subwoofer.
Speaker mode (United Kingdom only)
Set the presence and size of the speakers you have connected.
The sound for a speaker channel will not be output if you set the
presence incorrectly.
e
You will not get the most from your speakers if you set the size
q
incorrectly.
r
ı shows the default screen for the United Kingdom.
Use illustration Å as a guide to select the center and surround
speakers.
Press the cursor buttons (w er q) to select
1
the speaker and press [ENTER].
Press the cursor buttons (e or r) to change
2
the setting.
The speaker icon appears.
3 Press [ENTER].
This confirms the size of the speaker, small or large, and the
icons for speaker balance ("dB") and delay time ("ms")
appear.
Note
¡Set to "small" if you connect the recommended optional center
and surround speaker system (SB-PT96).
¡You cannot change the size and presence of the front speakers
(L and R) or the subwoofer (SW).
Channel balance
Adjust the balance of the center and surround speakers using the
test signal so that they are the same apparent level as the front
speakers when you are sitting where you would normally enjoy a
source. First adjust the unit's volume to the level normally used.
Icon
dB
O
Press the cursor buttons (w er q) to select
1
"Test" and press [ENTER].
A test signal is output in the following order:
L / C / R / RS / LS
Press the cursor buttons (e or r) to adjust
2
the level while the speaker is outputting the
signal.
3 Press [ENTER ] to stop the test signal.
To adjust subwoofer output
After playing a source to determine the approximate level, stop play
and return to this screen to adjust the level to your taste.
When you have finished changing the settings
Press the cursor buttons to select "Exit" and press [ENTER].
Speakers
Center
Surround (LS) Surround (RS)
Subwoofer