The Play And Record Timers; The Sleep Timer; Using The Timers Together - Technics SC-HDV600 Operating Instructions Manual

z PLAY/z REC
CLOCK/TIMER
A
CLOCK/TIMER
B
PLAY/ REC
C
SLEEP
SLEEP
40
RQT5941
CLOCK/
SLEEP TIMER CANCEL
1 2 3
≥10/-/--
4 5 6
7 8 9 0
SUB TITLE AUDIO
ANGLE
MENU
TOP MENU
ENTER
SETUP
RETURN
SLEEP
Using the timers

The play and record timers

A
Checking the timers
Press [CLOCK/TIMER] to select "z PLAY" (or "z REC").
The timer conditions are shown in the following order:
Start time / finish time / source / volume ("z PLAY" only)
The timers can be checked even if the unit is off.
Playing the unit after the timers are set
The unit can be used after the timers are set. Make sure the unit is
off before the set start time.
Turning the timers on and off
The timers come on at the set time if the [z PLAY/z REC] indicator
is on. Turn them on and off by pressing [z PLAY/z REC]
(a pages 38 and 39).
Note
If the unit is turned off while a timer is functioning, the finish time
setting will not be activated.
You can change the finish time for a timer while it is functioning by
following the same steps for setting the timer.

The sleep timer

C
Remote control only
This timer turns the unit off after a set time.
While playing a source
Press [SLEEP] to select the time (minutes).
Each time you press the button:
SLEEP 30 SLEEP 60
SLEEP OFF
To cancel the sleep timer
Press [SLEEP] to select "SLEEP OFF".
"SLEEP" goes out.
To confirm the remaining time
(While the timer is functioning)
Press [SLEEP].
The remaining time is shown for about five seconds.
To change the setting
Press [SLEEP] to display the remaining time, then press again to
select the required time.
Note
The sleep timer is canceled if CD editing is started.

Using the timers together

Any of the timers can be used together, but ensure the unit is off
before the start time for the record and play timers.
B
SLEEP 90
SLEEP 120