Table of Contents
Advertisement
A
COUNTER
B
Side A
Tab for side "B"
Tab for side "A"
To re-record
Normal tape
C
2 3
1
OPEN/CLOSE
2
DOLBY NR
3
REV MODE
High-position tape
Detection hole
1
NR
NR
Before recording
Selection of tapes for recording
The unit automatically identifies the type of tape.
Normal position/TYPE 1
High position/ TYPE 2
Metal position/ TYPE 4
A
To display the tape counter while recording
Press [COUNTER].
The counter is displayed for about five seconds.
Erasure prevention
B
The illustration shows how to remove the tabs to prevent recording.
To record on the tape again, cover as shown, being careful not to
cover the high position discrimination hole.
Volume and sound quality
Recordings are unaffected by changes to volume and sound
quality.
Preparatory steps
C
Do these steps before each recording.
Wind up the leader tape so recording can begin immediately.
1
Press [; OPEN/CLOSE], insert the
cassette with the tape facing in.
Make sure the cassette is fully inserted and press
[; OPEN/CLOSE] to close the deck.
2
Press [DOLBY NR] to select Dolby NR
on
or off.
("% NR" appears)
( a "Dolby noise reduction" page 31)
3
Press [REV MODE] to select the
reverse mode.
Each time you press the button:
!
: One side only records.
/ and $ : Both sides record (forward / reverse). "$"
automatically changes to "/" when [* REC
PAUSE] is pressed.
Erasing recordings
1. Turn [INPUT SELECTOR] to select "TAPE".
2. Press [DOLBY NR] so that "% NR" goes off.
3. Select the reverse mode.
4. Press [* REC PAUSE].
5. Press [w] or [q].
33
RQT5941
Hide quick links:
Advertisement
Table of Contents
