Remote Control - Panasonic SC-NE3 Operating Instructions Manual

Bluetooth
®
Pairing cannot be done.
≥ Check the Bluetooth device condition.
®
The device cannot be connected.
≥ The pairing of the device was unsuccessful or the registration has
been replaced. Try pairing the device again.
≥ This unit might be connected to a different device. Disconnect the
other device and try pairing the device again.
The device is connected but audio cannot be heard
through this unit.
≥ For some built-in Bluetooth
®
output to "SC-NE3" manually. Read the operating instructions for
the device for details.
The sound is interrupted.
≥ The device is out of the 10 m communication range. Bring the
Bluetooth device closer to this unit.
®
≥ Remove any obstacle between this unit and the device.
≥ Other devices that use the 2.4 GHz frequency band (wireless
router, microwaves, cordless phones, etc.) are interfering. Bring
the Bluetooth device closer to this unit and distance it from the
®
other devices.
≥ Select "MODE 1" for stable communication. (l 11)

Remote control

The remote control doesn't work properly.
≥ The remote control and this unit are using a different code.
(l right, "REMOTE ")
≥ Is the battery depleted or is the battery inserted incorrectly? (l 4)
devices, you have to set the audio
Messages
The following messages or service numbers may
appear on the unit's display.
"AUTO OFF"
≥ The unit has been left unused for about 30 minutes and will shut
down within a minute. Press any button to cancel it.
"DL ERROR"
≥ The software download has failed. Press any button to exit.
Please try again later.
≥ The server cannot be found. Press any button to exit. Make sure
that the wireless network is connected to the Internet.
"ERROR"
≥ Incorrect operation is performed. Read the instructions and try
again.
"F " (" " stands for a number.)
≥ There is a problem with this unit.
Note down the displayed number, disconnect the AC mains lead
and consult your dealer.
"FAIL"
≥ Updating or setting has failed. Read the instructions and try again.
"LEVEL 0"
≥ There is no link between this unit and the wireless network router.
Try the following operations:
– Check that the wireless network router is turned on.
– Turn this unit off and on again.
– Reset the wireless network settings. (l 6)
If the problem persists, consult your dealer.
"LEVEL j"
≥ When "D.CONNECT" is set to "ON" the Wi-Fi signal strength
cannot be checked. To check the Wi-Fi signal strength from the
wireless network router, set "D.CONNECT" to "OFF". (l 9)
"LINKING"
≥ This unit is communicating with the wireless network router
to complete the network settings.
Depending on the wireless network router this process may
take a few minutes. Try moving this unit closer to the wireless
network router.
"NOCONNECT"
≥ This unit is not connected to the network.
Check the network connection. (l 6)
"REMOTE " (" " stands for a number.)
≥ The remote control and this unit are using different codes. Change
the code on the remote control.
– When "REMOTE 1" is displayed, press and hold [OK] and
[ , AUX] for more than 4 seconds.
– When "REMOTE 2" is displayed, press and hold [OK] and
[SOUND] for more than 4 seconds.
15
VQT4U54