Screen Saver Mode; Setting Up The Unit Before Use - Panasonic KX-TG8070HK Operating Instructions Manual

Preparation
Battery level
Battery icon Battery level
High
@
Medium
?
Low
/
L When flashing: Needs
Panasonic Ni-MH battery performance
(supplied batteries)
Operation
In continuous use
In continuous standby
mode
Note:
L It is normal for batteries not to reach full capacity
at the initial charge. Maximum battery
performance is reached after a few complete
cycles of charge/discharge (use).
L To maximize battery life, it is recommended that
the handset batteries be fully discharged (used)
until / flashes once every few months.
L Actual battery performance depends on a
combination of how often the handset is in use
and how often it is not in use (standby).
L The battery level may not be displayed correctly
after you replace the batteries. In this case,
place the handset on the base unit and let it
charge for at least 8 hours.
10
to be charged.
Operating time
10 hours max.
100 hours max.

Screen saver mode

If the handset is not on the base unit
The backlight will turn off completely after 1
minute of inactivity, even when on a call.
To use the handset when it is in screen saver
mode, activate the handset display again by:
– pressing {^} or {V} when on a call
– pressing {i} for all other times
While charging
The backlight will be dimmed after 1 minute of
inactivity. The backlight can be turned off
completely depending on the setting (page 15). To
use the handset when it is in screen saver mode,
lift the handset to activate the handset display
again.
Setting up the unit before
use
Display language
1
{i} i {MENU}
2
Select r by pressing {^}, {V}, {<}, or {>}.
i {OK}
3
Press {^} or {V} to select "Display Setup".
i {OK}
4
Press {^} or {V} to select "Select
Language". i {OK}
5
Press {^} or {V} to select the desired
language.i {OK} i {i}
Note:
L If you select a language you cannot read: {i}
i {MENU} (right soft key) i {>} 2 times i
{OK} (right soft key) i {V} 2 times i {OK}
(right soft key) i {V} 2 times i {OK} (right
soft key) i {^}/{V}: Select the desired
language. i {OK} (right soft key) i {i}