Others; Software Update - Panasonic SC-NE5 Operating Instructions Manual

Others

Automatic standby
As a factory preset, this system will always turn off
automatically if there is no sound output and no
operation for approx. 30 minutes.
To cancel this function
1
Press [SETUP] repeatedly to select "AUTO OFF".
2
Press [3, 4] to select "OFF" and then press [OK].
≥ To turn automatic standby on, select "ON" in step 2.
≥ This setting cannot be selected when "FM" is the source.
≥ When connected to a Bluetooth
standby function does not work.
Changing the remote control code
When other Panasonic equipment responds to the
supplied remote control, change the remote control
code.
1
Press [ , AUX] to select "AUX".
2
While pressing and holding [SELECTOR] on the
speaker unit, press and hold [CD/RADIO] on the
remote control until this system's displays show
"REMOTE 2".
3
Press and hold [OK] and [CD/RADIO] on the
remote control for at least 4 seconds.
To change the mode back to "REMOTE 1", repeat the steps
above but replace the button pressed on the remote control
from [CD/RADIO] to [ , AUX].
device, the automatic
®

Software update

Occasionally, Panasonic may release updated
software for this system that may add or improve the
way a feature operates. These updates are available
free of charge.
The CD unit and the speaker unit need to be updated
separately.
DO NOT DISCONNECT the AC mains lead while
one of the following messages is displayed.
– "LINKING", "UPDATING" or "
(" " stands for a number.)
≥ During the update process, no other operations can be
performed.
Preparation
≥ Turn this system on.
≥ Connect this system to the wireless network. (l 10)
– Make sure that the wireless network is connected
to the Internet.
– If "D.CONNECT" is set to "ON", change the setting
to "OFF" and connect this system to a wireless
network that is connected to the Internet.
Updating the CD unit
∫
1
Download the latest firmware from the following
website and burn it to a CD-R to update the
firmware.
http://panasonic.jp/support/global/cs/
(This site is in English only.)
2
Insert the CD-R to the CD unit.
3
Press [CD/RADIO] repeatedly to select "CD".
4
Press [3, 4] to select "UPDATE? Y" and then
press [OK] to start the update.
≥ Select "UPDATE? N" to cancel the update.
{. After the update has finished, "SUCCESS" is displayed.
5
Disconnect the AC mains lead and reconnect it
after 3 minutes.
Updating the speaker unit
∫
1
Press [SETUP] repeatedly to select
"SW UPDATE" and then press [OK].
2
Press [3, 4] to select "UPDATE? Y" and then
press [OK] to start the update.
≥ Select "UPDATE? N" to cancel the update.
{. After the update has finished, "SUCCESS" is displayed.
3
Disconnect the AC mains lead and reconnect it
after 3 minutes.
≥ If there are no updates, "NO NEED" is displayed.
≥ Downloading will require several minutes. It may take
longer or may not work properly depending on the
connection environment.
∫ Checking the software version
1 Press [SETUP] repeatedly to select "SW VER." and then
press [OK].
{. The version of the installed software is displayed.
2 Press [OK] to exit.
%"
21
VQT4U60