Table of Contents
Advertisement
SC-UA7 GS RQT0B17-G En.fm Page 16 Monday, July 4, 2016 8:32 AM
To adjust the input level
1
Press [PLAY MENU] to select "INPUT LEVEL".
2
Press [Y, U] to select "NORMAL" or "HIGH" and
then press [OK].
Note:
•
You cannot adjust the input level during recording.
•
Select "NORMAL" if the sound is distorted during "HIGH"
input level.
•
Read the operating instructions of the portable audio
equipment for details.
Connecting an additional SC-UA7 unit
You can play sound from this unit to an additional
SC-UA7 unit.
Rear panel
of this unit
Audio cable
(not supplied)
1
Connect the additional SC-UA7 unit.
2
On the additional SC-UA7 unit:
Press [RADIO/EXT-IN] to select "AUX 1".
3
On this unit:
Start playback.
Note:
Sound effects are controlled separately by each unit. Select
the same sound effect on the additional SC-UA7 unit if
necessary.
D-IN mode and AUX mode
1
Press [RADIO/EXT-IN] to select "D-IN", "AUX 1" or
"AUX 2".
2
Press [PLAY MENU] to select "D-IN MODE" or
"AUX MODE".
3
Press [Y, U] to select the mode and then press
[OK].
MODE 1
Select this mode to use the Karaoke effect
(default)
function.
MODE 2
Select this mode when watching TV, movies
or using an external player with Karaoke
features.
16
16
Confidential
Until:
1 Aug 2016
Others
Auto off
This system automatically switches off when you do not
use it for approximately 20 minutes.
Press [AUTO OFF] to select "ON" and then press
[OK].
To cancel, select "OFF".
Note:
This function does not work when you are in radio source or
when a Bluetooth
Bluetooth
Rear panel of an
additional SC-UA7 unit
This function automatically switches on the system when
you establish a Bluetooth
device.
1
Press [SETUP] to select "BLUETOOTH STANDBY".
2
Press [Y, U] to select "ON" and then press [OK].
To cancel, select "OFF".
Note:
Some devices may take longer to respond. If you are
connected to a Bluetooth
system, wait for a minimum of 5 seconds before connecting
to this system from your Bluetooth
Touch sound
The system beeps when you touch any touch key on the
unit.
1
Press [SETUP] to select "BUZZER".
2
Press [Y, U] to select "ON" and then press [OK].
To cancel, select "OFF".
Note:
This function works even when the system is muted.
Software version
You can check the software version of the system.
1
Press [SETUP] to select "SW VER." and then press
[OK].
The software version is shown.
2
Press [OK] again to exit.
offset printing
®
device is connected.
standby
®
connection from a paired
®
®
device before switching off the
®
device again.
Hide quick links:
Advertisement
Table of Contents
