Others; Sleep Timer; Display Brightness - Panasonic SC-NE1 Operating Instructions Manual

Others

Sleep timer

The sleep timer can turn the unit off after a set time.
1
Press [SETUP] to select "SLEEP".
2
Press [3, 4] to set the time (in minutes) and then
press [OK].
"SLEEP 30" ,. "SLEEP 60" ,. "SLEEP 90" ,. "SLEEP 120"
^---------------------.
≥ The remaining time is indicated on the unit's display except
when other operations are performed.

Display brightness

The brightness of this unit's display can be changed.
1
Press [SETUP] repeatedly to select "DIMMER".
2
Press [3, 4] to select "ON" and then press [OK].
≥ To cancel the dimmer, select "OFF" in step 2.
Automatic standby
As a factory preset, this unit will always turn off
automatically if there is no sound output and no
operation for approx. 30 minutes.
To cancel this function
1
Press [SETUP] repeatedly to select "AUTO OFF".
2
Press [3, 4] to select "OFF" and then press [OK].
≥ To turn automatic standby on, select "ON" in step 2.
≥ When connected to a Bluetooth
standby function does not work.
8
VQT4U48
(----------------------J
"OFF" (Cancel)
® device, the automatic
Changing the unit and remote
control code
When other Panasonic equipment responds to the
supplied remote control, change the remote control
code.
1
Press [ , AUX] to select "AUX".
2
While pressing and holding [
press and hold [SOUND] on the remote control
until the unit's display shows "REMOTE 2".
3
Press and hold [OK] and [SOUND] on the remote
control for at least 4 seconds.
≥ To change the mode back to "REMOTE 1", repeat the steps
above but replace the button pressed on the remote control
from [SOUND] to [ , AUX].
/ AUX] on the unit,