Val6 KBE5L Owner's Manual page 7

Infra-red oil heater
Hide thumbs Also See for KBE5L:
Table of Contents

Advertisement

zlr GAUTION
5
Be careful of tempera-
ture of the floor
The heater is for use on Non Combustible Flooring unless the shieldins mat.
part #503002-05001 is used.
Materials of shielding mat : Glass cloth and Aluminum film / Dimension of
shielding mat : 1200 x 1200 x (3.5) mm (L x W x H)
A
6
Exposure of the Heater to
rain/snow and the operation
with wet hands are prohibited
Do not use the heater where exposed to rain/snow/etc, and do not operate it with
wet hands to avoid electric shock.
s
7
Do not use the Heater
in high altitudes
When the heater is used in an altitude higher than 1000m (3000 f0 above the sea
level, some adjustments will be required. Please contact your dealer about the
adjustments. The heater, if not duly adjusted, may lead to wrong burning or fire.
S
I
Stop using the Heater
when anything irregu-
lar is found
When wrong burning, smell or smoke, etc is found during the operation, please
stop immediately the operation and contact your dealer. If you continue using
the heater in such a situation, a fire likely takes place.
s
9
Do not move the
heater while burning
Do not move the heater, while burning or in operation, to prevent a fire when it
is overturned.
S
10
Caution for switching
off the Heater.
Before taking the electric plug off the outlet, please make sure the operating
lamp is OFF.
S
11
Tirrn off while refuel-
ing
Always make sure that the heater is turned off while refueling, to avoid a fire .
o
1 2
Use only the correct
voltage
Only electrical voltage and frequency specified on the model plate must be used,
to avoid a fire, electrical shock and/or damage.
A
13
Earth./Ground the
heater before opera-
tion
Please confirm if or not a grounded power cord is connected. To operate the
heater without proper grounding may result in electrical shock
s
14
Do not pull out the
power cord
When disconnecting the power cord, always pull out the plug, never the cord, to
unplug the cord. To pull out the cord may damage the cord itself and result in
fire through electrical shock or short circuit.
A
1 5
Do not damage the
power cord
Do not place excessive force on the cord by bending, pulling, twisting, pinching
or remodeling. Also, do not place any heavy objects on the heater, etc. that may
damage it, to avoid a fire and electric shock.
A
16
Use gloves
When cleaning up the heater, please use the gloves, to avoid any injury to hand
or finsers.
o
17
Make sure the flame is
extinguished
After shutting down the operation, please confirm that the flame is completely
extinguished, before you leave the place.
o
18
Do not dispose of the
Heater illegally
When you dispose of the Heater, please do not dispose of it illegally and consult
your local authorities or specialists on how to properly dispose of it.
o
19
Do not use the heater
in the following places
To prevent disaster, injury, etc., please do not use the heater in the following places:
. On vibrating and trembling floor.
. On slant floor (not horizontal).
. In stairs, emergency exit, doorways, etc.
. Near the unstable stacks/pilings-up.
. In windv, humid, dustv or metal particles floatinq areas.
S

Hide quick links:

Advertisement

Table of Contents
loading

Related Products for Val6 KBE5L

This manual is also suitable for:

Kbe5s

Table of Contents