Val6 KBE5L Owner's Manual page 10

l l
2
Remove the fuel cap and insert a handy suc-
tion pump into the fuel tank.
Watch the fuel gauge while refueling.
When the gauge reaches the maximum level,
stop refueling.
I Connecting the Power Supply
Make sure that the operating switch is "OFF",
th en pl u g th e h e a t e r 's p o w e r p l u g in t o
approved, grounded, three-wire extension
cord.
Plug extension cord into standard 120 volt/
60 Hz, 3-prong grounded outlet.
Tighten well the fuel cap, and wipe off any
s pilt .
Extension Cord Size Requirement
. 6 to 10 feet (1 .8 to 3 meters) long, use 18
AWG (0.75 mm2) rated cord
. 1 1 t o 1 0 0 f e e t ( 3 . 3 t o 3 0. 5 m et er s ) l ong,
use 16 AWG (1 .0 mm2) rated cord
Extension
l
2
Cord
3 ' 2. Op e r a ti n g Pr oce dur es . o o o. .. ... o....... . o. .... o o........
When smell, smoke, wrong burning, etc. takes place, stop immediately operation to avoid
a fire,and contact your dealer.
If the heater does not ignite with three consecutive tries. stop trying more than three (3)
times, to avoid a fire, and contact your dealer.
When using the heater, be careful so that the floor surface (in front of it ) may not get
overheated.
Do not operate the heater, while fuel tank is dirty and fbul, to prevent poor ignition or
wrong burning.
I lgnition Procedures
Observations
Not to miss the ignition, please do not leave the heater until you confirm that it is properly burning.
2
Use the fuel gauge to check if the fuel is suf-
ficiently filled up in the tank.
Set "ON" the operating switch, and the oper-
ating lamp will light and the heater will ignite
in about 5 seconds.
Stop completely the
in g l a m p h a s tur n e d
operation. The operat-
off, then try again the