Val6 KBE5L Owner's Manual page 13

I Inspection of the filter and drainage of water from the fuel tank.
Check whether or not the filter element is dirt
and fgul.
In case the filter element is dirty or clogged,
please replace it with a new one, and bind
firmly the cup with the tightening ring.
lf the water has collected in the cup, discard
water. Also, water in the cup means there is
water in the tank as well. Follow the instruc-
tions on page 11 and drain the water from
t h e fu el ta n k.
Fuel Strainer
Tightening Ring
O'--
o Rins Gasket
/A
ffi-=--"'o
O
f6)=-
rishrening Ring
W
ff
ffi I:.*,the
fuel cap, take out the tank inlet
ru
Restore the drain bott packing and tighten the
H fitter and insert a handv suction pump into
X
mlil:ilt;il'r
that fuer can nof reak out
m
ru the tank.
ffi
Wipe off kerosene orwaterspilt overthe tank.
. KBESS
o KBESL
w
ffi
w
ffi
Remove as much fuel as possible (with the
handy suction pump).
Restore the tank inlet filter and tighten firmly
the fuel cap.
Prepare an empty container of about 3 liters
(0.7 gallons) capacity:to hold kerosene and
water remained in the fuel tank, place the
container under the drain bolt (of the fuel
tank).
Later on, please remove with wrench the
drain bolt and tilt the fuel tank until the fuel is
completely drained out of the tank. (At the
same time, be careful not to lose the drain
bolt packing.)
Remove
Wrench
I
(24mm)
a
\&9\o,.",noo*
' a\