Val6 KBE5L Owner's Manual page 11

Do not adjust the angle of the main unit while the heater is plugged in operating or hot to
avoid sever bums and electric shock.
o KBESS
ffi
Loosen the knob bolt to move and set the
main heater unit at the desired angle, and
tighten the knob bolt firmly.
The vertical angle of the radiation disk is ad-
justable up to 20 degrees.
I Shut-Down Operation
' After the operation is shut down, please make sure that the flame is completelv
guished before leaving the place.
Observations
' To disconnect the power plug from the AC outlet, please make sure that the fan motor is stopped.
Turn "OFF" the operating switch, and the
heater flame will be extinguished,
then the
fan motor will also automatically stop after
about three (3) minutes, and finally the oper-
ating lamp willturn off.
3 -3 , Ho w to co n n g c t th g C on t r ol dg vi c @ . . . . . . . . . . . . . . . . . . . . . .
U ncoupl e t he term i n a ls (A ) a tta c h e d t o t h e
tip of white wires that come out of the burner base.
Co n n e c t both ma le a n d fe m a l e te rmin a ls ,
which are uncoupled, to the connectors (B) of
control device.
Observations
. When the heater is controlled by another device (such
as a thermostat or a timer), the heater could turn itself
on at any time.
ffi
ffi
rerminals (A)--_._
@ll
\ ltlt1
____T-
-e=-\Varue_
-rf-%a
connectors (B)
l f R t
\ ' _ )
To Control Device
,@